Bộ phát và lặp tín hiệu Wi-Fi công nghiệp Access point 2 cổng Ethernet Oring IAP-620_US

Thương hiệu: Oring | Tình trạng: Còn hàng
Liên hệ

Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X)

Gọi 0904251826 để được trợ giúp

Bộ phát và lặp tín hiệu Wi-Fi công nghiệp Access point 2 cổng Ethernet Oring IAP-620_US

Introduction

Overview

IAP-620 series are reliable IEEE802.11 a/b/g/n WLAN Access Point with 2 ports LAN. It supports 802.1X and MAC filters for security control. It can be configured to operate in AP/Bridge/Repeater/AP-Client mode. You are able to configure IAP-620 series by WEB interface via LAN port or WLAN interface.IAP-620 series provides dual Ethernet ports in switch mode, so that you can use Daisy Chain to reduce the usage of Ethernet switch ports. In addition, IAP-620 series also provides P.D. feature on ETH2 which is fully compliant with IEEE802.3af PoE P.D. specification. Therefore, IAP-620 series are one of the best communication solutions for wireless applications on the industrial network.

Features

  • High Speed Air Connectivity: WLAN interface support up to 300Mbps link speed

  • Support X-Roaming < 100 ms

  • Support wireless load balance

  • Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported

  • Support AP/Bridge/Repeater/AP-Client Mode

  • Switch Mode Supported: Daisy Chain support to reduce usage of switch ports

  • Dual redundant Ethernet port support redundant mode (Recovery time < 10ms)

  • Secured Management by HTTPS

  • Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper

  • Rigid IP-30 housing design

  • DIN-Rail and panel mounting enabled

Specification

Specifications

 

IAP-620

IAP-620+

Physical Ports

 

 

10/100Base-T(X) Ports in RJ45 Auto MDI/MDIX

                                                                                    2

P.O.E. PD port

Present at ETH2
Fully compliant with IEEE 802.3af   Power
Device specifi cation
Over load & short circuit protection
Isolation Voltage : 1000 VDC min.
Isolation Resistance : 108 ohms min

WLAN interface

 

 

Operating Mode

AP/Bridge/Repeater/AP-Client

Antenna and connector

2dBi ( b/g mode) / 3dBi ( a mode ) antenna on reverse SMA connector

Radio Frequency Type

DSSS, OFDM

Modulation

IEEE802.11a/n : OFDM with BPSK, QPSK, 16QAM, 64QAM
IEEE802.11b : CCK, DQPSK, DBPSK
IEEE802.11g/n : OFDM with BPSK, QPSK, 16QAM, 64QAM

Frequency Band

America / FCC:
2.412~2.462 GHz (11 channels )
5.180~5.240 GHz & 5.745~5.825 GHz ( 9 channels )
Europe CE / ETSI:
2.412~2.472 GHz ( 13 channels )
5.180~5.240 GHz ( 4 channels )
Japan(JP):
2.412~2.484 GHz ( 13 channels )
5.180~5.240 GHz ( 4 channels )
Canada(CA):
2.412~2.462 GHz ( 11 channels )
5.180~5.825 GHz ( 21 channels )

Transmission Rate

IEEE802.11b : 1/ 2/ 5.5/ 11 Mbps
IEEE802.11a/g : 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps
IEEE802.11n : up to 300Mbps

Transmit Power

802.11a: 13dBm ±1.5dBm
802.11b: 16dBm ±1.5dBm
802.11g: 14dBm ±1.5dBm
802.11n(2.4G@20MHz): 13dBm ±1.5dBm
802.11n(2.4G@40MHz): 12dBm ±1.5dBm
802.11n(5G@20MHz): 12dBm ±1.5dBm
802.11n(5G@40MHz): 12dBm ±1.5dBm

Receiver Sensitivity

802.11a: -68dBm ±2dBm@54Mbps
802.11b: -82dBm ±2dBm@11Mbps
802.11g: -68dBm ±2dBm@54Mbps
802.11n(2.4G@20MHz,MCS15): -64dBm ±2dBm
802.11n(2.4G@40MHz,MCS15): -60dBm ±2dBm
802.11n(5G@20MHz,MCS15): -64dBm ±2dBm
802.11n(5G@40MHz,MCS15): -60dBm ±2dBm

Encryption Security

WEP : (64-bit ,128-bit key supported)
WPA :
WPA2 : 802.11i(WEP and AES encryption)
PSK (256-bit key pre-shared key supported)
802.1X Authentication supported
TKIP encryption

Wireless Security

SSID broadcast disable

Protocol Support

 

 

Protocol

ARP, BOOTP, DHCP, DNS, HTTPs, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP (IEEE 802.1D)

LED Indicators

 

 

Power Indicator

PWR 1(2)(P.O.E.) / Ready :
Red On : Power is on and booting up.
Green On : Power is on and functioning Normally.

10/100TX RJ45 Port Indicator

Green for port Link/Act at 100Mbps. Amber for port Link/Act at 10Mbps

WLAN LEDs

WLAN Link /ACT : Green : Link, Orange : Poor signal
WLAN Strength : 1<25%, 2<50%, 3<75%, 4<100%

Fault

Red : Ethernet link down or power down

Fault contact

 

 

Relay

Relay output to carry capacity of 1A at 24VDC

Power

 

 

Redundant Input Power

Dual DC inputs. 12-48VDC on 6-pin terminal block

Triple DC inputs, 48VDC from PoE and Dual 12~48VDC on 6-pin terminal block

Power Consumption (Typ.)

6 Watts

Overload Current Protection

Present

Reverse Polarity Protection

Present

Physical Characteristic

 

 

Enclosure

IP-30

Dimension (W x D x H)

54.2(W) x 106.1(D) x 145.4(H) mm (2.13x4.18x5.72 inch.)

Weight (g)

803 g

807 g

Environmental

 

Storage Temperature

-40 to 85°C (-40 to 185°F)

Operating Temperature

-10 to 60°C (14 to 140°F)

Operating Humidity

5% to 95% Non-condensing

Regulatory approvals

 

 

EMI

FCC Part 15, CISPR (EN55022) class A

EMS

EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11

Shock

IEC60068-2-27

Free Fall

IEC60068-2-32

Vibration

IEC60068-2-6

Safety

EN60950-1

MTBF (Hours) (MIL-HDBK-217F2, GB, GC, 25°C )

352,982

352,594

Warranty

3 years

Order information

Model Name

Description

IAP-620+_EU

Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X)

IAP-620+_US

Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X)

IAP-620_EU

Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X)

IAP-620_US

Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X)

Download

Datasheet

Preview

Version

Release date

Size

 

DataSheet_IAP-620(+).pdf

No

 

May 03, 2016

1.16MB

 

Manual

Preview

Version

Release date

Size

 

User Manual_IAP-620 Serial.pdf

No

V1.0

May 03, 2016

1.57MB

 

QIG

Preview

Version

Release date

Size

 

QIG_IAP-620 Series.pdf

No

V1.1

May 03, 2016

959.17KB

 

Sản phẩm đã được thêm vào giỏ hàng

Số lượng:

Tổng tiền:

Sản phẩm đã được thêm vào giỏ hàng

Phí vận chuyển: Tính khi thanh toán

Tổng tiền thanh toán: